Additional information
| Standards | IEEE 802.1AB Link Layer Discovery Protocol (LLDP), IEEE 802.1d STP (Spanning Tree Protocol), IEEE 802.1p QoS/CoS Protocol for Traffic Prioritization, IEEE 802.1Q Virtual Local Area Network (VLAN), IEEE 802.1s MSTP (Multiple Spanning Tree Protocol), IEEE 802.1w RSTP (Rapid Spanning Tree Protocol), IEEE 802.1X Network Authentication, IEEE 802.3 10Base-T Ethernet, IEEE 802.3ab 1000Base-T Gigabit Ethernet, IEEE 802.3ad Link Aggregation (LACP), IEEE 802.3af/at Power over Ethernet, IEEE 802.3u 100Base-TX and 100Base-FX Fast Ethernet, IEEE 802.3x Flow Control, IEEE 802.3z 1000Base-X Gigabit Fiber, ITU-T G.8032 / Y.1344 ERPS v1/v2(Ethernet Ring Protection Switch) |
|---|---|
| Processing Type | Store and Forward |
| Flow Control | back pressure flow control, IEEE 802.3x flow control |
| Management | Console Port, DHCP Client, DHCP server, DHCPv6 client, DNS client/proxy, HTTP, HTTPS, ICMPv6, IP based Access Filter, IPv4/IPv6, LLDP, LLDPMED, Loop detection, NTP client, Port Mirror, Power lost warning, relay trigger, RMON, sFlow, SNMP v1/v2c/v3, SSHv2 telnet, syslog, Time Zone /Daylight Saving |
| Security | ACL(Port/Rate Limiters/ACE), ACLs for filtering/policing/port copy, ARP Inspection, Authorization (15 levels), Guest VLAN, IP MAC binding, IP source guard, MACbased Authentication, Port Security Limit Control, Portbased/Single/Multi 802.1X, Private VLAN, QoS Assignment, RADIUS accounting, TACACS+, VLAN assignment, WEB/CLI authentication |
| L2 Switching | ARP, BPDU guard, DHCP snooping, Error disable recovery, G.8032 v1/v2, GARP/GVRP, IGMP filtering, IGMPv2 snooping, IPMC throttling / filtering leave proxy, Link Aggregation static/LACP, Loop Guard, MEP, MLD snooping, Port/MAC/Protocol/IP Subnetbased VLAN, VLAN trunking |
| L3 Switching | DHCP option82, IP route |
| QoS | 802.1p Queueing, DiffServ (DSCP), Input priority mapping, Port egress shaper, Port/Queue/ACL policer, Queue egress shaper, Scheduler mode, Storm control for Unicast/Multicast/Broadcast, Tag remarking |
| Power Saving | ActiPHY, IEEE 802.3az EEE power management, PerfectReach |
| Network Redundancy | ERPS v1/v2 (<50ms), port trunk with LACP, STP/RSTP/MSTP |
| Configuration | CLI, Http, Https, SNMP v3, SSH, Telnet, TFTP |
| PoE | PoE alive check and remote reboot PD device, PoE output scheduled, POE/POE+ port power allocation, Power budget protection |
| System / Diagnostic | Dual Image Protection, PING, PING6 |
| SNMP MIBs & RFC Standards | 2, 3, and 9), IEEE 802.1 MSTP, IEEE 802.1AB LLDPMIB (LLDP MIB included in a clause of the STD), IEEE 802.1X (PAE MIB included in a clause of the STD), IEEE 802.3ad (LACP MIB included in a clause of the STD), IEEE802.1Q bridge MIB 2008, RFC 1213 MIB II, RFC 1215 TRAPS, RFC 2613 SMON – PortCopy, RFC 2674 VLAN MIB, RFC 2819 RMON (group 1, RFC 2863 interface group MIB using SMI v2, RFC 3411 SNMP management frameworks, RFC 3414 userbased security model for SNMPv3, RFC 3415 viewbased access control model for SNMP, RFC 3621 LLDPMED Power (PoE) (No specific MIB for PoE+ exists), RFC 3635 Ethernetlike, RFC 3636 802.3 MAU, RFC 4133 entity MIB v3, RFC 4188 bridge, RFC 4292 IP forwarding table, RFC 4293 management information base for the Internet Protocol (IP), RFC 4668 RADIUS auth. client, RFC 4670 RADIUS accounting, RFC 5519 multicast group membership discovery, TIA 1057 LLDPMED ( MIB is part of the STD) |
| Switching Fabric | 12Gbps |
| Queues | 8 |
| Max. Number Of VLANs | 4095 |
| VLAN ID Range | VID 1 to 4095 |
| Memory Buffer | 4Mbits |
| Jumbo Frame | 9.6Kbytes |
| MAC Table Size | 8K |
| IGMP Group | 1024 |
| Transfer Rate | 000pps for Gigabit Ethernet port, 1, 14, 148, 488, 800pps for Fast Ethernet port, 880pps for Ethernet port |
| RJ45 Ports | 4*10/100/1000 Base-T(X) with PoE-PSE(30W/Port), Auto-MDI/MDI-X, Auto-Negotiation, Full/Half Duplex |
| PoE Pin Out | 2, 3, 6 (End-span, for pin 1, Mode A), V-, V+ |
| Fiber Port | 2*100/1000Base-(F)X SFP slot |
| Wavelength | Depends on SFP modules |
| LED Indicators | Ethernet ports: Speed/Link/Active, Fault, Master, PoE: On-connected to PD devices, Power 2, Ring, SFP: Link/Active, System: Power 1 |
| RS232 Serial Console | 1, 1*RS232 in RJ45 connector with console cable, 200bps, 8, baud rate 115, N |
| Relay Contact | 1A resistive, 24 VDC |
| Input voltage | Dual 48-55VDC redundant power inputs |
| Power Connection | 1 removable 6-contact terminal block |
| Overload Current Protection | Present (Slow-Blow Fuse) |
| Reverse Polarity Protection | Present |
| System Power Consumption | Max. 7.5W full loading |
| Max. PoE Power Budget | 120W |
| PoE Power Output | 30W max. per PoE port |
| Housing | IP30 protection, Metal |
| Dimensions | 54(W) x 142(H) x 99(D) mm |
| Mounting | DIN-Rail Mounting, Wall Mounting |
| Operating Temperature | EOT: -40°C ~ 75°C (-40°F ~ 167°F), STD: -10°C ~ 65°C (14°F ~ 149°F) |
| Storage Temperature | -40°C ~ 85°C (-40°F ~ 185°F) |
| Ambient Relative Humidity | (non-condensing), 5 to 95% |
| EMI | CE EN55022/EN61000-6-4 Class A, FCC Part 15 Subpart B Class A |
| EMS | IEC61000-4-2 (ESD), IEC61000-4-3 (RS), IEC61000-4-4 (EFT), IEC61000-4-5 (Surge), IEC61000-4-6 (CS), IEC61000-4-8 (Magnetic Field) |
| Free Fall | IEC60068-2-32 |
| Shock | IEC60068-2-27 |
| Vibration | IEC60068-2-6 |
| Green | RoHS Compliant |
| MTBF (Telcordia SR-332, Issue 3, GB, 25oC) | TBD |
| Warranty | 5 Years |
| Brand | Leonton |
Reviews
There are no reviews yet.